JPF Crochet Club
Your points account click tracker is not activated! Click this image to activate your tracker.  Click this image to log into your account.Point Tracker
Not activated.
Click to Activate tracker.
Join one of our groups!
JPFun Newsletter

Buy from Amazon
Buy from Amazon

Two in one Pattern

Picture Frame

Designed By Julie A. Bolduc

This pattern can be used as a coaster or as a picture frame fridgie depending on how you finish it. I used a picture cut out of a magazine and glued it to a piece of cardboard cut from a box of margarine sticks. Please Recycle!
Click to download the PDF version.

Materials Needed
For Coaster
Small amount worsted weight yarn Red Heart Acrylic in Raspberry was used.
For Picture Frame Fridgie
Same yarn as above.
Plastic Lid from a Potatoe Chip Can
White yarn Scrap Worsted Weight Yarn.
Magnet Sheet cut into a 2" circle
Hot Glue
Yarn needle for weaving in ends.


Gauge: 4sc=1"
Yarn Thickness 3mm
Finished Size: 5"diameter
Skill Level: Beginner

As Coaster

RND 1: Ch3, work 10 dc in 3rd ch from hook. Join w/slst to first dc.

RND 2: Ch1. Sc in same st as slst. 2sc in each dc around. Join w/slst to ch1.

RND 3: Ch3. 2dc in next sc. *1dc in next sc. 2dc in next sc. Rep from * around. Join w/slst to top of ch3.

RND 4: Ch1 sc in same st as slst. 2sc in each dc around. Join w/slst to ch1.

RND 5: Ch6. *Sk next sc. Sc in next sc. Ch5. Rep from * around. Join w/slst to first ch of ch6. Fasten off.

Use 3 Strands of white yarn 28" long on a yarn needle. Weave the 3 strands all at once around the perimeter so that the ends come out on the right side. Do not tighten. Just tie in a bow.

Now finished as a coaster. Make several in different colors!

Now to make the Picture frame. Using the lid as a template, trace and cut out a circle of thin cardboard and a picture the same size. You need to cut inside the line you made. You may have to trim it to fit.

Glue the picture to the cardboard. If you are using a photograph, you can use acid free paper and two faced tape if you wish. Tuck the picture into the lid face up so that the image is not covered by the plastic.

Then lay the lid face up on the coaster which should be laying down right side down. Then draw up the 3 strands of yarn to tighten around the rim of the lid. Tie a bow. Glue the magnet to the back.

Design written on Tuesday, July 20, 1999. Copyright©1999 by Julie A. Bolduc all rights reserved. p108014

JPF Crochet Club where Crocheting is Just Plain Fun
This crochet pattern is for personal use only and is not to be resold.